Z-height Adjuster for Ortur Laser Master 2 Pro Laser Engraving Machine: All You Need to Know

As everyone knows, Ortur laser master 2 pro is an affordable, user-friendly and easy-to-setup laser engraving machine, it helps people develop an easy hobby and establish professional-looking works. Ortur laser master 2 pro has a lot of add-ons to choose from, making the at-home DIY more fun. Among them,the Z-height adjuster is a simple but practical accessory.

Ortur Z-height adjuster is also called Z-axis lifting device(ZLD), it is only compatible with Ortur laser master 2 pro laser engraving machine, and will make the laser engraver even easier to use.

The Purpose of Z-height Adjuster for Ortur Laser Master 2 Pro Laser Engraving Machine

Z-height adjuster for Ortur laser master 2 pro has two main purposes

  1. Make the focal adjustment easier.
  2. Lengthen the moving range of the laser module in the z-axis direction.

Please read on and I will explain these two features separately

How to Adjust the Focus for Ortur Laser Master 2 Pro Laser Engraving Machine?

Without the Z-height adjuster, when adjusting the focus for Ortur Laser Master 2 Pro, you need 3 steps

Step 1: Loosen the thumbscrew on the right of the laser module

Step 2: Move the laser module up and down until getting the smallest laser spot

Step 3: Tighten the thumbscrew

With the Z-height adjuster, when adjusting the focus for Ortur Laser Master 2 Pro, you only need to twist the knob.

  • Twistclockwise to slide up the laser module
  • Twistcounterclockwise to slide down the laser module

Why Do You Need A Longer Z-axis Moving Range?

When engraving on the surface of thick material, you need to lift the laser module higher. Because the Z-height adjuster leaves more space above the laser module, it lengthens the moving range of the laser module in the z-axis direction for about 12mm, making it possible to engrave on thicker materials.

If you have more questions about Ortur laser master 2 pro laser engraving machine and Z-height adjuster, please contact us by sending emails to support@buybestgear.com or chat online with us.


1 comentário


  • Martin Kuchinke

    Hallo seit ich die z-achsen höhenverstellung eingebaut habe reagiert der y-endschalter nach dem graviervorgang nicht mehr. der Laser fährt voll in den Endanschlag und die Zahnräder überdrehen. wenn ich über die Hometaste zurückfahre funktioniert dies. Ich arbeite mit lightburn.

    Gruß
    Martin Kuchinke


Deixe um comentário

Tenha em atenção que os comentários precisam de ser aprovados antes de serem exibidos